How to connect O-ring Chains Remarks to connect general O-ring Chains

one.A connecting website link of an O-ring Chain for basic application is pre-coated with grease at the pins. Prior to connection, confirm the grease over the surfaces of pins, and in case the level of grease is small, apply grease with bare hands. (If gloves are utilised, the grease is going to be absorbed through the gloves.)
Illustration: Once the connecting website link (I) of an O-ring chain for common application is
shipped, O-rings are fitted in the roots with the pins. Should the O-rings come loose because of vibration through transport, refit the O-rings in to the roots with the pins.
In this case, be sure you return the grease collected at the roots on the pins on the central surfaces on the pins, extra at portion A than at portions B proven in the over illustration. (Portions A is worn because of sliding with the bushings.)
2.The chain may be most simply linked on the teeth of a sprocket. Engage the links at the two ends on the chain with the sprocket teeth and fit connecting pins. If your sprocket is usually moved, the chain can also be connected around the loosened side.
three. Connecting method
one.Verify that O-rings are connected for the roots with the pins.
two.If the level of grease utilized over the connecting pins is smaller, coat the pins with grease with the central portions.
three.Insert the connecting pins into the bushings with the inner hyperlinks at both ends.
four.Verify that the grease is utilized on the total face of your O-ring, and match the O-ring onto the connecting pins.
five.Insert the connecting pins in to the connecting plate and while pressing the connecting plate, install the spring clip. Verify whether the head (the end without a split) on the spring clip is turned during the feeding direction of your chain. (See the next illustration.)
six.Be sure to verify that the spring clip is securely fitted in the clip grooves from the connecting pins.
This completes jointing in the connecting hyperlink. Note that grease about the surfaces of connecting pins and O-rings is usually eliminated in the course of installation operate. In this case, re-grease employing the grease around the surface on the base chain or the grease within the polyethylene bag during which the connecting website link was contained.